How to Dismantle and Refurbished Baby Grand Piano

Download Article

Download Commodity

If you're planning on getting rid of an upright pianoforte, transporting it intact is very difficult. Information technology's much easier to detach the whole piano and move information technology in pieces. Dismantling a pianoforte requires patient work and you won't be able to utilize the piano over again because you'll probably damage pieces while taking it autonomously. If this is okay with you lot, so start by unscrewing all of the outer pieces to expose the piano's inner workings. Then remove the keyboard and action brackets. Finally, take apart the balance of the piano construction to get it set for disposal.

1. 1

   Open the central comprehend and piano lid. The key cover is located on the keyboard over the keys, and the lid is on the superlative portion of the piano. Both of these pieces should open easily. Slide the key cover back past lifting slightly and pushing it backwards until information technology stops. The chapeau on top of the piano is on a swivel and opens from the front.^[ane]

   • Sometimes the piano lid is screwed down or secured in some way. If the chapeau won't lift off, search for screws holding it down. Remove them to lift the lid.

2. 2

   Unhinge the pianoforte desk-bound to expose the harp. The desk is the function of the pianoforte in front of you where the sheet music sits. With the lid open, you can expect and achieve behind the desk. At that place is a hinge on each side of the desk-bound securing it to the piano body. Undo those hinges by sliding the hooks out of each socket to gratis the desk. Then elevator the desk off the piano.^[ii]

   • You may demand help for this step. Pianoforte desks can be heavy, and a 2nd person volition make the lifting much easier.
   • Some pianoforte builders secure the desk-bound with screws. If yous find screws belongings the desk to the trunk, remove them to elevator the desk-bound off.

   Advertisement

3. 3

   Unscrew the piano key embrace. The primal comprehend is normally attached with screws. Later you remove the pianoforte desk, look behind the cover and find the screws. Remove them and lift off the key cover.^[3]

4. four

   Pull out the lower lath to expose the inner mechanism. The lower board is the flat, vertical section underneath the pianoforte where the pes pedals come out from. Information technology houses some of the pianoforte's inner machinery. Usually, it is only secured past a pin and spring. Await under the keyboard for a metal pivot. Push this upwards to release the board. Then guide the board out of position.^[4]

   • Proceed your hand on the board when you push the pin. It could come loose suddenly and fall on y'all.

5. five

   Unscrew the tiptop lid. The concluding outer slice is the top lid, which you lifted upwards at the starting time. It is secured with hinges. Unscrew the hinges from the piano torso to free the lid. And so elevator the lid off.^[v]

   • Put all of these forest pieces you're removing in a safe identify. If you exit them out and near the work surface area, yous could trip on them while you're working.

   Advertisement

1. one

   Remove the muffler felt from the action. The muffler felt presses down on the piano's strings to dampen the sound. It runs across the piano strings about eye level when you're sitting. Usually the muffler is held down with a wingnut on one side. Unscrew that wingnut and lift the muffler out when it comes loose.^[6]

   • Sometimes the muffler doesn't have a wingnut. In this example, press the spring on the side of the muffler to disengage its mechanism. Then lift it out of the piano.

2. 2

   Unscrew the bolts from the action brackets. The piano action houses the hammers that strike the strings. It is located but above the keyboard. The action is held downwardly by 4 metallic brackets connected to the pianoforte with 4 knob screws. Turn all the knobs counterclockwise to remove them. Once all 4 are removed, the action is no longer secured.^[seven]

   • Commonly you can plow these knobs by paw without a screwdriver. If at that place are slots for a screwdriver in the knobs, nevertheless, so use a screwdriver.

3. 3

   Pull the action machinery forward and so lift it off. With the knobs unscrewed, the activeness is gratuitous to move. Grab 2 of the brackets from the top and pull the action forward until it reaches about a 45-caste bending. Then elevator direct up to remove it.^[8]

   • If y'all want to continue the action in skillful condition, simply lift from the brackets, considering touching the internal machinery could cause damage. If y'all are planning on scrapping the piano pieces, then don't worry where you lot take hold of to lift the action out.
   • Having some other person to help lift the activeness out is a proficient idea because the activity could be unexpectedly heavy.

4. 4

   Lift each key off the keyboard. The keys merely rest on pins without beingness secured downwards, and then they just elevator off. Pull each key direct up to remove the keyboard.^[9]

   • Put the keys aside into a bucket or box. Music shops or professional musical instrument technicians may want to buy the keys to restore other pianos. Attempt posting your keys online or asking local music shops if they are interested in buying spare parts.

   Advert

1. i

   Loosen the tension in every string on the harp for safety. With the keyboard and action removed, you lot tin hands access the piano harp. This is a large, metal frame secured to the back of the piano where the strings are attached. Practice not practise annihilation else until you loosen the strings. The harp has dozens of metal strings under high tension, and if one snaps it can cut you. Observe the tuning pegs at the acme of the harp. Then turn each one counterclockwise until the string sags.^[10]

   • For a faster option, y'all tin buy a string turner. This works like a drill that wraps around the tuning fork and loosens or tightens strings chop-chop.
   • If you lot want to salve or sell the strings, remove them entirely by clipping them with wire cutters correct below the tuning peg later you lot loosen them.

2. 2

   Unscrew the central bed from the piano torso. The primal bed, where the keys sabbatum on before you removed them, is attached to the piano with a serial of screws. The screw locations depend on the manufacturer. Look upwardly the back legs of the key bed for any screws holding information technology to the body. Then look along the bottom of the central bed. Remove any screws you come beyond, then pull the central bed off.^[11]

   • If you're throwing this piano out anyway, then yous don't accept to be then careful. Use a mallet or sledgehammer to break the key bed away from the piano torso and make the chore much faster.
   • With the primal bed gone, the remainder of the piano may be off balance. Be careful continuing behind it and keep children away from the piano until y'all're washed working.

3. 3

   Lay the piano on its back. With the key bed gone, the piano might tip over, so it's safer to finish the work with the piano on its back. Stand up behind the piano and slowly guide it down to the floor.^[12]

   • This slice is heavy, and then have someone else effectually to aid.
   • Exist careful to avoid trapping your fingers to the floor when you guide the pianoforte downwards.

4. four

   Remove the piano side supports. The final outer parts of the piano are the two planks on each side. On most upright pianos, this is where the wheels are. Look within the piano frame for screws property these planks downwards. Remove all of them then pull the side planks off.^[13]

   • These planks will also come up off with a few hits from a hammer. If you aren't trying to proceed the wood in good condition, take a mallet and pound the planks from the within out. A few clean hits should dislodge them.

5. 5

   Pull off the pianoforte harp to complete the chore. The final slice to remove is the piano harp. It is attached to the piano body with bolts and screws. Work your manner effectually the whole harp and remove all the screws you see. So lift the harp off to complete the piano disassembly.^[14]

   • On some upright pianos, the harp is glued downward to the woods. In this example, even if you remove all the screws, you won't exist able to get the harp out.
   • Remember that the strings should be loose before you remove the harp.

   Ad

Add together New Question

• Question

  How do you remove the tuning pins? Is there a special tool?

  

  David Gibson

  Community Answer

  There is a special tool yous can buy online, simply it substantially a wrench with a socket, and will take forever to remove all the pins. There is no metric or English socket that will fit, but the 1/4 inch bulldoze female end of a socket fits perfectly. Have the smallest you lot have - 9/32 or 7 mm - and flip it and insert it in an electrical drill. The pins should come up out very easily.

• Question

  Do I need to remove pins earlier removing the harp?

  

  While the tuning pins are non actually attached to the cast-fe plate ("harp"), they practice pass through the plate. With a grand piano, the plate tin can exist pulled straight upward later on removing the hat, and can slide up and off of the pins nonetheless in the pivot block. An upright piano, spinet through upright grand sizes, cannot be slid off of the tuning pins equally the keybed limits movement in that direction. If the keybed is fully removed so it may work, but at that point it would accept just been easier to build a piano mock-upward from plywood and lumber.

• Question

  How do I remove keys from a piano?

  

  For antiquarian square grands, lift the band of forest just on the forepart side of the keys. It will slide vertically. In one case removed, the key assembly tin can be slid out intact.

• Question

  I desire to remove the piano harp strings intact. How do I do that?

  

  Unfortunately, that is not viable. You would terminate upwards removing the plate and so building a construction and re-stringing the apparatus to create the "look" of an intact strung piano. The tuning pins are non connected to the plate ("harp"). You would need to remove the wooden pivot cake, which is glued to the piano structure, then reattach it to the removed plate. Additionally, the strings bend through pins in wooden bridges that are fastened to the wooden sound lath. Removal of the strings from the bridges would get out slack in the strings that would let them autumn off of the hitch pins, which are the but zipper points of the string that is directly attached to the plate.

• Question

  Are there parts in a baby yard pianoforte that are recyclable?

  

  The wood and the superlative of a baby m piano tin can be reused or recycled.

• Question

  How do you dismantle a piano?

  

  Drew Hawkins1

  Community Answer

  Dismantling a pianoforte is hard and you won't exist able to use information technology once you lot take it apart. Employ a screwdriver to unscrew the cover and the top lid so you tin can take off the outer pieces and attain the inner parts. Loosen the strings and the central bed so you lot can pull out the harp and whatsoever other internal pieces yous tin can remove. In one case the inside is empty, use your screwdriver to have off the sides and legs.

• Question

  What kind of metal is in a piano?

  

  Drew Hawkins1

  Community Respond

  The metallic pianoforte wire that'southward used for the pianoforte strings is made from tempered high-carbon steel. It's a specialized blazon of wire, also known as leap steel, that is durable and able to hold the tension for years and years, which is what allows a piano to stay tuned.

• Question

  Is it unsafe to accept autonomously a piano?

  

  Drew Hawkins1

  Community Answer

  Pianos can be very heavy, so the biggest take chances involved with taking i apart is having something fall on yous. The harp on the inside also as the meridian cover and the body of the piano could seriously injure you lot if they fall on you. Be very conscientious and accept somebody assistance you stabilize the pianoforte when you lot're taking it apart.

• Question

  How practise I know if the legs on my piano are removable?

  

  If it is an upright piano, they are probably attached at the top past screws to the wooden plate nether the keys. And so, yes, they are removable, if you don't mind offset removing the keys.

Enquire a Question

200 characters left

Include your email address to get a message when this question is answered.

Submit

Advertising

Video

• Most of the wood, hardware, keys, and metal in the pianoforte can be recycled or sold. Craftsmen would be particularly interested in the wood, especially if this is an old pianoforte. Try selling the loose pieces before throwing the piano away.

Thanks for submitting a tip for review!

Advertising

• Do non dismantle a piano if yous still programme on using it. You will demand a professional person to rebuild it from scratch.

Advertisement

About This Commodity

Commodity Summary X

It's possible to dismantle a piano and then information technology's easier to go rid of, merely go on in heed that yous won't exist able to utilize the piano again one time you lot do. To dismantle a piano, all you demand is a screwdriver. The get-go affair you'll need to do is unscrew the cover and meridian lid then you lot can remove the outer pieces and access the keys and internal parts. In one case those are off, you lot'll need to loosen the strings and the key bed that holds them in place so you lot tin pull out the harp and internal pieces. Later you've removed everything, the last thing you lot'll demand to practice is lay the piano downward on it'south back and take off the sides and legs. For tips about how to remove the side planks with a hammer, keep reading!

Did this summary help you?

Cheers to all authors for creating a folio that has been read 241,092 times.

Did this article aid you?

jonesmiltarthe.blogspot.com

Source: https://www.wikihow.com/Dismantle-a-Piano

Share this post